Lifting it off the pallet, to remove bolts. Below.

Above: This is me bringing it in. Don't say anything. I had the lathe backward on the forks. I Had to lower and reverse it.

Above, This is what you see, when the lathe is correct on the forks, good going Vern.

Above, moving to final position and bolting to stand. Finding the bolt holes.

Above, lathe stand, I hope in the right place and as clean as you'll ever see it.

Above, this was the 12x37 trailer lift, didn't think the small tractor had it in it, 1000lb lift. Still bolted to pallet. This lathe stayed around for 2 weeks. Also you can see the mod I did, to the trailer, a fork lift gate. You can see I got the expanded metal going the wrong way on the gate, oh well. It's hard to tell it's wrong.