Below, is the location of shop expansion. The area is to the left of the two car garage.
                                        I'm hopping to take over wifes single garage, for the dirty shop. Garage doors are insulated.
                                        I'm doing this to get away from opening and closing two car garage door, letting out my cold or hot air.

Below, area here is the west end of the clean shop. End of bench that goes all around shop with new 2 ton arbor press. 50 gal hot water heater and 20 ton hydraulic press on right.

Above you can see through to third garage. That is the only opening to get heat and cooling to the other side, so ductwork may or may not have to be added. A 1.5 or 2 ton air handler will be added to this side of shop above right. The condenser (heat pump) will be added just out side of wall to right, west under patio. Behind door, going into single garage, I'm adding 60 amp sub panel it has 100 amp buss bars, wired with 6 gage, black, white, green and red. I'll run 1 1/2" electrical gray plastic conduit from 80 feet away. Yes your seeing wood paneling.

Above, 36" break, this will help with any plenum stuff, duct work.

Above is some of the machine tools that will be moving to dirty shop. Lathe on far left, blue and white. This will become wifes parking spot.

Above, outlined in green, is area to have heat and cooling. Just found out about mini remote systems, so now some changes coming.
Got to check with Xringer.