X2 Mod

Above, is the X2 mini mill/drill, with stand to the right. You can see I drilled 2 inches of aluminum to raise the mill so it would clear the drip pan rail.

SX3 Mods

This is a picture of repositioning of micro switches control box. The aluminum arrow has to be removed, it's screw will be re-used. Remove the center gibbs screw from the front of table. Drill a 1/4" hole in middle of micro switch mounting plate, them counter sink. Use the arrow screw just removed. Mount micro switch box to center gibbs location. The locking cap electrical cord has to be ground down a little to fit. Now the micro switch is in the middle of table.  Table moves in equal distance both left and right.

This was the spindle wrench. Handle removed and re-bent for a locking key.